Silicon Image SataRaid Bedienungsanleitung PDF herunterladen (Seite 7)

installing a conventional hard drive.

For Existing Hard Drives with Data

1. As the BIOS boots press Ctrl+S or F4 when prompted to enter

the RAID BIOS.

2. At the next screen select Create RAID Set, then press Enter.

3. At the next screen select Mirrored then press Enter.

4. Select Manual configuration, then press Enter.

5. Select the Source drive, press Enter.

6. Select the Target drive, press Enter.

7. Enable Disk Copy, select Ye s , then press Enter.

Note: Enable Disk Copy – Copy current content of source driver to

mirror drive; Disable Disk Copy – RAID 1 set formed must be

repartitioned and reformatted to guarantee the consistency in their

contents.

8. Press Ctrl+E to exit the BIOS.

9. When asked Are you sure to exit(Y/N)?, press Y to exit and

reboot.

Note: If during boot the RAID BIOS reports an RAID1 set is in

Rebuild status, The rebuild will continue after boot sequence is

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Keine Kommentare

Silicon Image SataRaid Bedienungsanleitung Seite 7